Initial Settings:
1. Set the camera HDMI output to auto resolution mode.
2. Set the video mode to infrared remote control mode.
3. Connect HDMI converter with the camera, connect the servo cable of shutter controlling with the remote control receiver.
4. Initialize the Camera by pressing the shutter once to get the camera out of review mode.
5. Install the optical fiber on converter, stick the other end of the optical fiber over the window of infrared receiver on the camera.
Important Note:
You need to have a transmitter with a 3 position switch. Map this 3 position switch to a spare channel and connect the servo cable from the converter to this channel. If there is no connection, HDMI converter works only as a HDMI to AV converter.
The control of 3-pos switch:
1. Up: Takes a photo(Shutter is pressed)
2. Middle:Shutter is off / Recording is off
3. Down: Video recording is on.
It is very important that the 3-position switch is set in the middle (neutral) position before you power up your converter. ( Note : converter powers up when you turn on the camera or power supply of receiver) When the shutter control 3-pos switch is in the middle(stop/neutral) position, the red LED is on constantly. If there is no signal from the receiver, the red LED flashes 4 times per second, it reminds customer to check if the receiver is powered and the transmitter is turned on.
Taking Photos：
Toggle the 3-POS switch from middle position to the up position, the camera will start taking photos until the 3-POS switch is toggled to the middle position. In this mode the red LED flashes 2 times per second.
Recording video:
Toggle the 3-POS switch from the middle position to down position, the camera starts recording a video till the 3-POS switch is toggled to the middle position. Video is saved in this position. In this mode, the RED LED blinks continuously.
Attention:
There must be a 5 second interval between each operation of the 3-POS switch. e.g. Switching from neutral to recording position and then back to neutral (recording stop). Please wait for 5 seconds between each mode change. The 5 second interval is required by the camera firmware. It allows the camera to clear the buffer and safely write the video file to storage. Operating the the 3-POS switch without observing the 5 second gap will cause the camera to hang and can result in corrupt video files.
HDMI converter - Input voltage must not exceed 6 volts. Do not connect a high voltage receiver to converter. The receiver power supply should be between 4.8V-6V, Operation beyond 6 Volts will result in damage the unit and potentially the camera and voids all warranties.
Compatibility list:
sony@5000；sony@6000 ；
gopro3
Packing List：
RCD3015M converter module 1 piece
Black red yellow AV cable 1 piece
60cm long, 0.75mm PMMA optical fiber cable 1 piece (Only 15cm is required for normal operation)
