3DR MicroTelemetry radio Set for mini APM and nano APM

MX Radio V2 gets smaller size and lighter weight than the similar products on market, it is based on the firmware of 3DR Radio and combined our years of design experience, MX Radio-APM V2 applied double UART ports.

Specifications:

1,SIZE：MX Radio-USB V2（including SMA antenna mount）：47.3*16*6.2 mm；

      MX Radio-APM V2（including SMA antenna mount）：42.0*16*6.2 mm

2, Weight：MX Radio-USB V2（not including antenna）：3.2g；

          MX Radio-APM V2（not including antenna）：2.9g；

3, MX Radio-USB applied Micro-USB port; MX Radio-APM applied double 4P 1.0mm ports;

4, 915 or 433MHz；

5, 100 mW maximum output power (adjustable);

6, -117 dBm receive sensitivity;

7, Support Android OTG;

8, 2-way full-duplex communication through adaptive TDM;

9, Transparent serial link;

10, MAVLink protocol framing;

11, Frequency Hopping Spread Spectrum (FHSS);

12, Configurable duty cycle;

13, Error correction corrects up to 25% of bit errors;

14, Open-source SIK firmwar;

15, Configurable through Mission Planner and APM Planner;

16, Supply voltage: 3.7-6 VDC (from USB or DF13 connector);

17, Transmit current: 100 mA at 20 dBm;

Receive current: 25 mA;

      Diagram（MX Radio-APM as the sample）

     Default parameter

Accessories included:

1, Main board of MX Radio-USB V2  1 piece, main board of MX Radio-APM V2  1 piece;

2, Antenna 2 pieces;

3, Cable for connecting APM  1 piece;

    ATTENTION:

1) If MX Radio-APM V2 is connected with APM, the APM must be powered alone, it can’t be powered through USB port, the ground station baud rate is 57600;

2) The default baud rate is 11, in order to achieve further distance, you can select 20 from configure option of ground station; You need to be careful on this process, or it won’t restore the configuration automatically and can’t communicate anymore. 

Details for connection: