There are currently no product reviews.
NOTE: Reviews require prior approval before they will be displayed
NOTE: Reviews require prior approval before they will be displayed
|
Scisky-Mul-A FPV flight control board is integrated with a Scisky 32 A flight control board (supports both Cleanflight and BaseFlight firmware, onboard buzzer and three color LED tail lights), a MW OSD, a DCDC power and a 5.8G analog video transmitter (max output is 500MW), it also includes several kinds of connection port. Barometer sensor (MSR5611) and compass (HMC5983) are already installed on the FC board. Please make a choice for the compatible receiver ( DSMX/DSM2, SFHSS or FlySky) when you place the order. The picture for the plug and play receiver:
It includes: one integrated FPV FC, one compatible receiver, one converter adapter, two cables.
Features:
1) Supports both Cleanflight and Baseflight firmware;
2) Onboard buzzer and three full color LED tail lights;
3) The 5.8G analog video transmitter applied a clock generator of 10PPM accuracy (most clock generators on market are of 30PPM accuracy)
4) The 5.8G analog video transmitter supports FAT SHARK goggles;
5) The video transmitter port is IPX;
6) Supports GPS ( only available when the UART2-RX port is not connected with the integrated receiver)
7) STM32F103CBT6 main control/72MHz;
8) Onboard sensors: MPU6050, HMC5983(optional), MSR5611(optional);
9) Supports outside compass and sonar;
10) Onboard receiver (optional);
11) Option for digital video transmitter port ( at the same position for onboard receiver, so customer can only choose one between the two);
12) Working voltage: 7.4~18V (equals 2~4S lipoly, for 6S use, customer needs to place an order specially)
13) The optional integrated receivers are: DSMX/DMS2 compatible receiver, SFHSS compatible receiver and Flysky compatible receiver.
Notes: Scisky-Mul-A doesn’t support 2203 brushless motors or 2204 and above motors.
Scisky-Mul-A appearance (unit:mm)
 Picture of the back of Scisky-Mul-A circuit
 Scisky-Mul-A tail part：
 How USB connect with CF or OSD? When the rear switch (at the end of the board) is turned to FC(marked on the board) side, the connecting USB is connected with CF; When the rear switch is turned to OSD side, it indicates the USB is connected with OSD (its firmware is MW OSD V1.5).
Ports
Notes: the port names marked in black is on the front of the board, the port names marked in red is at the back of the board, the blue names show the specific receiver ports
Frequencies for matching the switch status:
Notes: 0---off; 1---on
All goods are not marked are three packs of shops Customer Videos: See all 0 videos
Customer Images: See all 0 images
This product was added to our catalog on Sunday 15 May, 2016. For more information, please visit this product's webpage. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||