There are currently no product reviews.
NOTE: Reviews require prior approval before they will be displayed
NOTE: Reviews require prior approval before they will be displayed
|
It can work with HP03S and HP08S 2S version, it can save power and generate less heat from the motor. Description:
You are selling the 12T and 11T pinion gear, could you please advise me what is 12T or 11T best use with, like 12T with HP0x good upgrade for V120D01?
IMO,V120D01 is very similar to 4#6, V120D02 is close to 4G6, V120D03 is close to 4G3, V120D01, 02, 03 is colse to each other, of course you can use HP03T tail motor on V120D03.Normally, we installed 12T or 14T pinion gear on HP06V2 on all of the three , my engineer believe 18T is too much for working with HP06V2.
We don't have a 11T pinion gear, but we have 10T pinion gear, it is for brushless modification on solo pro nine eagle and MSR helicopter but not so successful because no converter ESC for this kind of helicopter.
Best Regards!
Jon
Attention: Please clean the motor shaft and the inner hole of the pinion by ethyl alcohol firstly, then daub a bit of the Anaerobic adhesive on the shaft where the pinion gear will be installed. Wait for 1 minute or so, be sure the Anaerobic adhesive be dried and then you can put it into use. If the hole of the pinion gear is tight and not easy to push it onto the shaft, you can grind the shaft by fine emery paper and try again. All goods are not marked are three packs of shops Customer Videos: See all 0 videos
Customer Images: See all 0 images
This product was added to our catalog on Sunday 24 May, 2015. |