10T Pinion gear 1.5mm 0.3M Trex 150 pinion gear

High quality processed, it can be used on MCPX, MSR, Trex-150 helicopters.

1. Description:
- Material: Brass
- Teeth: 10
- Modul: 0.3
- Bore: 1.5mm
- Height: 3mm

2. Included: 
1 x Brass Pinion 10T 0.3M/1.50 Bore.


Please clean the motor shaft and the inner hole of the pinion by ethyl alcohol firstly, then daub a bit of the Anaerobic adhesive on the shaft where the pinion gear will be installed. Wait for 1 minute or so, be sure the Anaerobic adhesive be dried and then you can put it into use.
If the hole of the pinion gear is tight and not easy to push it onto the shaft, you can grind the shaft by fine emery paper and try again.