There are currently no product reviews.
NOTE: Reviews require prior approval before they will be displayed
NOTE: Reviews require prior approval before they will be displayed
|
frequency can be 32K) Brushed ESC: continuous working current is 4.2A, max current is 6A(5S); Integrated with DCDC voltage booster circuit( output 5.0V/500Ma), it can supply power for other device through IIC and UART port; The hardware of the FC is based on Naze 32, test firmware is cleanflight Naze V1.9.0 and V1.8.1. Notes: It will enters binding mode only after powered of 10 seconds automatically, you need to try to get transmitter closer to the board, something like 5cm will be better. No binding button on the board. Typical use:
For firmware flash: If there is a mistake happened when the firmware was flashing. Please soldering the cable like the following:
 please flash firmware by Flash Loader Demo, after that, please remove the soldered cable. Then you can flash the latest firmware or other version firmware through Cleanflight GUI.
About the integrated receiver setting:
   How to set up brushed ESC mode after the firmware is flashed: Set MOTOR_PWM_RATE parameter >2000 but<32000, the details are the following: Under CLI order enters “set motor_pwm_rate=2000”, then click “enter”, then input ”save” and click “enter” again. So you can set our 32 FC to brushed ESC mode after the firmware is flashed (note: 2000 means the signal frequency for controlling the brushed motor is 2KHz, the maximum you can set is 32000, that is 32KHz)
The following is the screenshot for changing the parameter of MOTOR_PWM_RAT:
For VTX connection, please check the following picture:
Please purchase this cable from this link: http://www.overskyrc.com/1mm-4p-jst-plug-vtx-connection-on-scisky-32-brushed-fc-p-740.html
All goods are not marked are three packs of shops Customer Videos: See all 0 videos
Customer Images: See all 0 images
This product was added to our catalog on Wednesday 10 May, 2017. |