7T Pinion gear 1.0mm 0.3M for Nano CPX helicopter

P021
2g

$1.90

Submit a wholesale Inquiry
2 reward points
Qty: Unit(s)

Modulus:0.3
Shaft hole:1.0mm
Tooth: 7T
Highth:3mm

It is for using HP03SPE on Nano CPX helicopter or for original brushed motor use.
Attention:

Please clean the motor shaft and the inner hole of the pinion by ethyl alcohol firstly, then daub a bit of the Anaerobic adhesive on the shaft where the pinion gear will be installed. Wait for 1 minute or so, be sure the Anaerobic adhesive be dried and then you can put it into use.
If the hole of the pinion gear is tight and not easy to push it onto the shaft, you can grind the shaft by fine emery paper and try again.



There are currently no product reviews.
NOTE: Reviews require prior approval before they will be displayed

All goods are not marked are three packs of shops


Customer Videos: See all 0 videos
Customer Images: See all 0 images
Friday 22 May, 2015

This product was added to our catalog on Friday 22 May, 2015.

synageva